The overhang limit is clearly marked on the seat for both rear and forward facing. There’s a warning label on the side of the seat that includes the requirement for the cupholders to be installed at all times. They clearly indicate the recline options, overhang allowance, as well as the recline and panel use requirements. The seat labels are colour coded with blue labels addressing the rear facing use and orange labels addressing the forward facing use. Graco has stepped up their game when it comes to labeling and the Canadian Extend2Fit is no exception! Width at widest point (cupholders): 19.75 inches.Shell height: 28 inches tall with headrest fully extended.Lowest harness position: 7 inches with insert.Lower anchor weight limit: 45 pounds in both rear facing and forward facing modes.Forward facing height range: 27-49 inches.Forward facing weight range: 22-65 pounds.Rear facing height range: 18 inches up to 1 inch below the adjuster handle when fully extended (not to exceed 49 inches).We’ll use this review to illustrate the differences, most of which are around rear facing use. While we are still very big fans of this seat and its versatility, there are some major changes between the Canadian and American versions. See the section below to check to make sure your rear-facing seat is installed correctly.The much-loved Graco Extend2Fit convertible car seat has made its way to Canada. Grab the vehicle seat belt near the buckle and tighten the seat belt by pushing down on the child car seat and pulling up on the shoulder belt.Ĭheck the angle of the child car seat.Insert the tongue into the vehicle seat belt buckle before releasing the seat belt.Note that convertible child car seats have two paths for the belt – one for rear-facing mode and one for forward-facing mode. Check the label on the child car seat for the correct path for the seat belt.This will lock the belt in most vehicles. Pull the shoulder belt portion out completely, hold onto it before you pass the seat belt through the recommended path.
HOW TO INSTALL A GRACO EXTEND2FIT ON AIRPLANE HOW TO
Your child car seat may have built-in locking clips, follow the instructions on the child car seat for using the locking clips.Ĭheck your vehicle owner's manual to learn how to lock the seat belt. Infant seats installed without the removable base must be secured with the seat belt.Ī locked seat belt will help keep the child car seat tight after you have installed it. Use the seat belt if you cannot use the UAS lower anchorage bars, if you are using your infant car seat without its base or if there are no lower anchorage bars in your vehicle. As you push down on the child car seat or on the removable base, tighten the UAS strap. If your child car seat has built-in locking clips, follow the instructions on the child car seat for using the clips.Īttach the hooks or connectors to the UAS lower anchor bars.
These airbags are powerful and can hurt children if they inflate during a crash.
All vehicles have air bags in the front dash. Installing your rear-facing child car seat in your vehicleĪlways install the rear-facing car seat in the back seat of your vehicle. You may find this easier to do before you install the child car seat in the vehicle.Īs your child grows, check the fit and readjust the harness.
Some child car seats allow you to adjust the harness height by moving the headrest up or down. Adjust the harness straps so they are at or just below your child's shoulders.
0 kommentar(er)
